Safety Data Sheet

Wood Tints

4.00 out of 5 based on 2 customer ratings
(2 customer reviews)

SEAL-ONCE offers a full line of rich Semi-Transparent Tints & Stains that preserve and enhance the natural beauty of wood while protecting it from harmful UV rays. The UV blockers present in our tints prevent graying and nano-sized pigments penetrate the surface for a longer lasting, more durable color.

Our Semi-Transparent Tints & Stains are available in a variety of rich colors to match your project needs. All of our colors can be added to our wood sealers for a sophisticated finish, including NANO, NANO+POLY, EXOTIC, and MARINE.  Tints are made for 1 gallon of sealer, so order 1 per gallon.

Colors:
Natural Cedar Light Brown Brown Bronze Cedar Redwood Mahogany Cape Cod Gray Shale Gray Battleship Gray Black

FIND A RETAILER

OR

BUY ONLINE

Product Details

  • Eco-friendly
  • Ultra-low VOC
  • UV protection
  • Non-toxic; will not harm pets, plants, people or marine life
  • Soap & water cleanup

 

  • All surfaces should be cleaned before sealing for best penetration and performance.
  • Remove all old coatings, dust, debris and loose material. Remove oil, grease, algae, grime, mill glaze and mold and mildew stains with appropriate cleaners. Recommend Seal-Once All Wood Cleaner.
  • Test absorbency after cleaning by sprinkling water on surface. If the water does not readily penetrate the surface, stripping will be necessary to remove old coatings.
  • Do not use if air or surface temperature is below 50°F/10°C or above 95°F/35°C.
  • Do not apply in rain or when rain is expected within 24 hours.
  • Mix complete contents of tint bottle into gallon can of SEAL-ONCE.
  • DO NOT THIN. Mix well. Stir contents or shake thoroughly prior to use.
  • Test a small area to ensure acceptable appearance and penetration.
  • Follow the application instructions on the can of your base product (NANO, NANO + POLY, EXOTIC or MARINE).
  • For best results, apply in the shade and out of direct sunlight.
  • Apply to all surfaces and ends.
  • Do not use with other waterproofing products.

 

  • Allow approximately 2-3 hours for surface to dry, depending on temperature and humidity.
  • Allow approximately 24 hours for full cure, depending on temperature and humidity.
  • When recoating, apply as soon as previous coat has penetrated and surface is damp, not wet. Second coat must be applied within one hour of applying the first coat.
  • Clean all application equipment with warm soapy water.
  • Disposal: soap and water cleanup; no special disposal procedure needed.
  • Store above 32°F/0°C to protect from freezing.
  • Shelf life (unopened): 3 years

 

Please refer to the Maintenance & Care instructions for your base product (NANO, NANO + POLY, EXOTIC or MARINE).

0