FREE Ground Shipping on Color Samples & All Orders Over $50

All Wood Cleaner

5.00 out of 5 based on 1 customer rating
(1 customer review)

SEAL-ONCE® All Wood Cleaner prepares wood surfaces for the application of SEAL-ONCE wood finishes & sealers. The concentrated formula penetrates the surface to loosen dirt & remove discoloration, mold & mildew stains without the use of harsh chemicals. It restores the original color of the wood, making it look like new. 2 lbs makes 7 to 8 gallons & covers 3,000 to 4,000 sq. ft.

Recommended Use:
Decks Docks  Railings Shingles Shake roofs Siding Fences Outdoor furniture Play structures Log homes Hard and soft woods Pressure treated lumber

FIND A RETAILER

OR

BUY ONLINE

Product Details

  • Eco-friendly
  • Non-toxic; will not harm pets, plants or people
  • Standard 2lb bottle dilution Makes 7-8 Gallons
  • 1 Gallon typically covers 600-800 sq. ft.
  • Zero chlorine, bleach & phosphates
  • Removes mold, mildew & fungi stains
  • Removes discoloration and brightens wood
  • Soap & water cleanup, Biodegradable

 

  • All surfaces should be dry for best penetration and performance.
  • Remove any furniture and fixtures from area to be cleaned. Remove all dust, debris and loose material from surface.
  • Add ½ cup of powder per gallon of water. Stir thoroughly to ensure all powder has dissolved.
  • Allow the prepared solution to sit for 15 minutes to fully activate prior to use.
  • Apply to all dry wood surfaces using a pump-up garden sprayer.
  • Allow cleaner to sit on the wood surface for 30 minutes before rising off thoroughly using a pressure washer.
  • For best results, do not apply in direct sunlight or on hot surfaces. If surface becomes dry, mist with water to reactivate cleaner.
  • Do not apply to surfaces that have been stained using SEAL-ONCE Semi-Transparent Tints.
  • Once wood surface has been cleaned, rinsed and has dried completely, SEAL-ONCE products can be applied.

 

  • Allow approximately 4-6 hours for surface to dry completely, depending on temperature and humidity before applying SEAL-ONCE Wood Sealers.
  • For best results, allow 12-24 hours for surface to dry.
  • Clean sprayer equipment, sponges and brushes with warm soapy water.
  • Disposal: soap and water cleanup; no special disposal procedure needed.

 

Do not use SEAL-ONCE All Wood Cleaner on surfaces that have been sealed or stained with SEAL-ONCE products as it will remove the product and require the surface to be resealed.

Surfaces that have been treated with SEAL-ONCE can be cleaned using a mixture of 1 gallon warm water, 14 oz. bleach, and 1 oz. of Dawn® dish detergent. Apply this cleaning solution with a sprayer and allow to sit for 20 to 30 minutes on the wood surface before rinsing with water using a garden hose with a nozzle.

This cleaning solution can be used to remove airborne mold and mildew stains, dirt and grime from the wood surface. SEAL-ONCE will prevent and resist any water, mold and mildew penetration.

$5 Off Your 1st Order.

Sign Up to be a SEAL-ONCE insider and get early access to special offers & new products.

0