Wood Tints

0 out of 5 based on customer ratings
(0 customer reviews)

SEAL-ONCE offers a full line of rich Semi-Transparent Tints that preserve and enhance the natural beauty of wood while protecting it from harmful UV rays. The UV blockers present in our tints prevent graying and nano-sized pigments penetrate the surface for a longer lasting, more durable color.

Our Semi-Transparent Tints are available in a variety of rich colors to match your project needs. All of our colors can be added to NANO GUARDTM and NANO GUARDTM PLUS POLY Premium Wood Sealers for a sophisticated finish.

Colors:
Natural Cedar Light Brown Brown Bronze Cedar Redwood Mahogany Cape Cod Gray Shale Gray Battleship Gray Black

FIND A RETAILER

OR

BUY ONLINE

Product Details

  • Eco-friendly
  • Zero VOCs
  • UV protection
  • Non-toxic; will not harm pets, plants, people or marine life
  • Soap & water clean-up

 

  • All surfaces should be cleaned before sealing for best penetration and performance.
  • Clean all dust, debris and loose material. Remove oil, grease, algae, grime, mill glaze and mold and mildew stains with appropriate cleaners. Recommend Seal-Once All Wood Cleaner.
  • Test absorbency after cleaning by sprinkling water on surface. If the water does not readily penetrate the surface, stripping will be necessary to remove old coatings.
  • Do not use if air or surface temperature is below 45°F/7.22°C or above 95°F/35°C.
  • Do not apply in rain or when rain is imminent.
  • Mix complete contents of tint bottle into gallon can of Seal-Once.
  • DO NOT THIN. Mix well. Stir contents or shake thoroughly prior to use.
  • Apply two coats wet on damp with a brush, pump-up garden sprayer, air-assisted and/or airless sprayer. Use 17-19 tip and medium to coarse spray pattern. Brush out any puddles.
  • For best results, apply in the shade and out of direct sunlight.
  • When applying in direct sunlight and wood surface is hot, spray with a mist of water and apply Seal-Once immediately on dampened surface.
  • Apply to all surfaces. Apply Seal Ends Once® to wood ends. (link to Seal Ends Once page)
    Do not use with other waterproofing products.

 

  • Allow approximately 2-3 hours depending on temperature and humidity before subjecting surface to light foot traffic.
  • Allow 12-24 hours for full cure, depending on temperature and humidity.
  • When recoating, apply as soon as previous coat has penetrated and surface is damp, not wet.
  • Clean sprayer equipment and brushes with warm soapy water.
  • Disposal: soap and water cleanup; no special disposal procedure needed.

 

Please refer to the Maintenance & Care instructions for your base product (Original Formula, PolyBlend, Poly, etc.).