All Wood Cleaner

0 out of 5 based on customer ratings
(0 customer reviews)

SEAL-ONCE® All Wood Cleaner prepares wood surfaces for the application of SEAL-ONCE wood finishes and sealers. The concentrated formula penetrates the surface to loosen dirt and remove discoloration, mold and mildew stains without the use of harsh chemicals. It restores the original color of the wood, making it look like new.

Recommended Use:
Decks Docks  Railings Shingles Shake roofs Siding Fences Outdoor furniture Play structures Log homes Exotic wood Hard and soft woods Pressure treated lumber Composite decking

FIND A RETAILER

OR

BUY ONLINE

Product Details

  • Eco-friendly
  • Non-toxic; will not harm pets, plants or people
  • Biodegradable
  • Zero chlorine, bleach & phosphates
  • Removes mold, mildew & fungi stains
  • Removes discoloration and brightens wood
  • Soap & water clean-up

 

  • All surfaces should be dry for best penetration and performance.
  • Remove any furniture and fixtures from area to be cleaned. Clean all dust, debris and loose material from surface.
  • Add ½ cup of powder per gallon of water. Stir thoroughly to ensure all powder has dissolved.
  • Allow the prepared solution to sit for 15 minutes to fully activate prior to use.
  • Apply to all dry wood surfaces using a pump-up garden sprayer.
  • Allow cleaner to sit on the wood surface for 30 minutes before rising off thoroughly using a pressure washer.
  • For best results, do not apply in direct sunlight or on hot surfaces. If surface becomes dry, mist with water to reactivate cleaner.
  • Do not apply to surfaces that have been stained using SEAL-ONCE Semi-Transparent Tints.
  • Once wood surface has been cleaned, rinsed and has dried completely, SEAL-ONCE products can be applied.

 

  • Allow approximately 4-6 hours for surface to dry completely, depending on temperature and humidity.
  • For best results, allow 12-24 hours for surface to dry.
  • Clean sprayer equipment, sponges and brushes with warm soapy water.
  • Disposal: soap and water cleanup; no special disposal procedure needed.

 

Do not use SEAL-ONCE All Wood Cleaner on surfaces that have been sealed or stained with SEAL-ONCE products as it will remove the product and require the surface to be resealed.

Surfaces that have been treated with SEAL-ONCE can be cleaned using a mixture of 1 gallon warm water, 14 oz. bleach, and 1 oz. of Dawn® dish detergent. Apply this cleaning solution with a sprayer and allow to sit for 20 to 30 minutes on the wood surface before rinsing with water using a garden hose with a nozzle.

This cleaning solution can be used to remove airborne mold and mildew stains, dirt and grime from the wood surface. SEAL-ONCE will prevent and resist any water, mold and mildew penetration.